A new razor comming

[Nord Razors]

I haven't receive the razor yet, but I am in bed with this Swine Flu H1N1. What a beast.
If it was soap, it would be Grooming Dept.

I will test the razor in my secret lab, after I get in the mood.

Get well soon, Randy! The parcel should reach you today or tomorrow, so you don't have much time to recover. Chop chop.

 

[Randy]

Get well soon, Randy! The parcel should reach you today or tomorrow, so you don't have much time to recover. Chop chop.

Ay ay sir...
Time to spread the virus in the whole local post office

 

[Ventastic]

Testing set has arrived at my home in Austria. @dawid, you have spared no effort!

 

[Holyzeus]

Are SOTD pic’s allowed?

 

[Nord Razors]

Are SOTD pic’s allowed?

Absolutely! I would definitely appreciate them.

 

[Ventastic]

Absolutely! I would definitely appreciate them.

No problem if the T number is visible?

 

[Nord Razors]

No problem if the T number is visible?

No problem. There is nothing to hide.
Just don't share your thoughts publicly, that's the only restriction for now.

 

[Ventastic]

No problem. There is nothing to hide.
Just don't share your thoughts publicly, that's the only restriction for now.

Mums the word.

 

[Randy]

The razor finally arrived. Let's see ...

 

[slapo]

Turns out hot tap water can warp it the head (top cap and safety bar), so it's best to use slightly warm or colder water.
I've previously mostly used carbon infused PLA, which didn't seem to suffer the same ill effects, but that is not the case here.

 

[Randy]

Turns out hot tap water can warp it the head (top cap and safety bar), so it's best to use slightly warm or colder water.
I've previously mostly used carbon infused PLA, which didn't seem to suffer the same ill effects, but that is not the case here.

What is warp ?

And do you mean with the 3D ?

Edit: Now I got it

 

[Nord Razors]

Turns out hot tap water can warp it the head (top cap and safety bar), so it's best to use slightly warm or colder water.
I've previously mostly used carbon infused PLA, which didn't seem to suffer the same ill effects, but that is not the case here.

I completely didn't think about that.
Yes, it may happen if hot water is used. PLA softening temperature is around 60 ℃, so it must be kept below that value.
60 ℃ is already above the pain threshold for the majority of people, so I didn't think about it at all.

@Paper Plane @Randy @bartje-p @J349 @Cleanfoam @bagman @Bauhaus @Ventastic @p.b @Holyzeus @Ice09 @spacemonkey42
Please be aware of @slapo discovery and avoid hot water.

 

[Holyzeus]

Turns out hot tap water can warp it the head (top cap and safety bar), so it's best to use slightly warm or colder water.
I've previously mostly used carbon infused PLA, which didn't seem to suffer the same ill effects, but that is not the case here.

I had already thought about that as I normally use very hot water.

 

[Bauhaus]

I haven't receive the razor yet, but I am in bed with this Swine Flu H1N1. What a beast.
If it was soap, it would be Grooming Dept.

I will test the razor in my secret lab, after I get in the mood.

Get well, quickly, Randy!

 

[Holyzeus]

Remember to change the clips each time, I didn’t and they do seem to go loose.